Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
04-13-2018, 11:39 PM | #11 |
Senior Member
Join Date: Sep 2015
Location: Martensville, Saskatchewan
Posts: 963
|
Re: My 1970 GMC Project
Ok I got that figured out. After lots of measuring and double checking, I found that the outboard side of the pan was dropping. So after some discussion with OriginalThor and my dad, I made a decision. I made a releif cut that allowed me to make the correction and carried on welding. Still quite a bit of welding left but then I can finally say that the driver side is done!
|
Bookmarks |
|
|