Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
10-03-2020, 09:19 PM | #30 |
Registered User
Join Date: Jun 2013
Location: Grand Rapids Michigan
Posts: 291
|
Re: '67 K10 swb big block "The Mutt"
What happened was when I tightened up the pan bolts the paper gasket split in half and the inner half of the gasket dropped into the pan. Luckily I immediately noticed the drop in oil pressure (because of the horrendous valve train noise) and shut the engine down before any real damage was done. Lesson learned, don’t use a cheap pan gasket, and don’t over tighten the bolts. In the photo below you can see part of the gasket is missing on the drivers side front of the pan.
__________________
My build thread: http://67-72chevytrucks.com/vboard/s...96#post7439296 |
Bookmarks |
|
|