07-26-2021, 01:59 PM | #30 |
Registered User
Join Date: Jul 2009
Location: San Jose Ca
Posts: 2,871
|
Re: Used Parts Build
Attempt two!
Bent and welded Where it will end up Learned a lot (or more accurately-learned that I don't know a lot) with this little mount I made. Most importantly I am no where near as strong as I thought I was...The bracket is made out of .100 stainless. Even with the notches cut I ended up using a cut off wheel to thin out the areas that weren't notched. I didn't account for bend radius or the distortion in the areas where the bend would occur. it still came out significantly better than if I was to try to make it by hand but there is definitely a learning curve to this stuff as well. I think when I get more space I am going to invest in a finger brake.
__________________
David Used parts build: http://67-72chevytrucks.com/vboard/s...d.php?t=638991 My brother's Nova: http://www.67-72chevytrucks.com/vboa...d.php?t=727985 Rear suspension rework: http://www.67-72chevytrucks.com/vboa...d.php?t=750557 Instagram: myfabguy |
Bookmarks |
|
|