47-55.1 S-10 swap - Clutch & Brake pedal (& master cylinder question)

[crushermechanic]

How much modification does the S10 pedal assembly require to fit in a 51? I found a set yesterday and should be able to pull it out tomorrow.

[joedoh]

Originally Posted by crushermechanic

How much modification does the S10 pedal assembly require to fit in a 51? I found a set yesterday and should be able to pull it out tomorrow.

easy peasy, trim the front of it so it fits under the dash and the booster part fits against the firewall. I like to add a plate that angles it 5 degrees so the front brake reservoir doesnt starve under panic braking. this picture is before I drilled and bolted to the under dash. if you use the clutch assembly it will have extra support rods that you bolt to the floor. edit: I gues i had a couple pictures of the clutch assembly bolted to a s10 pedal. you can see the extra support rods in the pictures.

[crushermechanic]

Thank you for the info. I have an auto so I won't need the clutch assembly. Do you use the S10 master and booster or something else

[joedoh]

Originally Posted by crushermechanic

Thank you for the info. I have an auto so I won't need the clutch assembly. Do you use the S10 master and booster or something else

yep s10 master and booster, the booster rod is already the right length, and so is the pin to the master. why mess with a working setup?

if you arent using the clutch side, why not unbolt it and send it to brandon (b-mac)?

[b-mac]

For sure Crusher.
Let me know what you want for it.

I would even swap you the wider automatic brake pedal if you want.

PM'ing you.

Thanks for the idea Joe