1Bad37: C5 Corvette Meets '37 Chevy...

[68c10airstream]

Hi christian, been waiting for the pics. Very very nice fab work!!! Fantastic that you went outside of the box and did irs, and a tilt box besides. This will be a rolling showcase for your work!! A little late for trans repair thoughts but the condition you spoke of first where you hold the shifter in gear and then the clunk, then good to go is typical of mainshaft walking back and forth. Because gears are cut at an angle they end load the shaft. There will always be more force under acceleration one way than you could ever do decelerating the other way. Watch thrust washer clearance (if so equipped) between washer and the case as an example. Do't mean to make you worry, just thoughts i wanted to share. If i lived close would love to feel the handling firsthand! Keep the pics coming. Good luck, Brian F.