|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-09-2005, 11:43 PM
|
#1 |
|
Registered User
Join Date: May 2005
Location: Brazoria, Texas
Posts: 60
|
Disc brakes installed & bad neutral safety switch
I have finally finished on up the installation of an ECE disk brake kit on the ol' '69 GMC. I also rebuilt the upper & lower control arms with new bushings & ball joints. I pulled out the brake pedal to modify it per the instructions. That was a pretty tough job removing it from under the dash. When I finished it all up & put the truck back on the ground, it would not turn over the starter. I automatically assumed it was the starter. I pulled it the next day, after already ordering one. I found the solenoid wire had some exposed wire. I went ahead & replaced the starter & the bad wire. It still would not start. Then I unplugged the neutral safety switch & bypassed it with a jumper & BINGO!!
Could the switch have gone bad or is there an adjustment on it? Please help, Rally Nova
__________________
1969 GMC C-1500 1972 Rally Nova 1988 Monte Carlo SS 2004 GMC 2500 Crew Cab |
|
|
|
06-10-2005, 12:01 AM
|
#2 |
|
Registered User
Join Date: Jun 2002
Location: Knoxville Tenn.
Posts: 3,058
|
Adjustment.
__________________
56 Chevy Bel-Air 2dr. HT (purchased new) 71 Chevy Cheyenne SWB PU (502HO) 65 GMC short bed step--work in progress and my gofer |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
