|
11-14-2023, 11:07 PM
|
#1 |
|
Registered User
Join Date: Aug 2008
Location: greensboro nc
Posts: 673
|
disc conversion
Hvae been looking at disc conversion for 1969 Panel truck. Noticing most say they are same thru 1987. I take that to mean .If I find a set off of any of those years it will bolt on. Correct or am I missing something?
__________________
Only the stupid know too much to learn something new. |
|
|
|
11-14-2023, 11:20 PM
|
#2 |
|
Registered User
Join Date: Jun 2013
Location: Somewhere
Posts: 3,052
|
Re: disc conversion
I've read that at least half ton front crossmembers can be swapped from 71 to some year as a way to get front disks. Don't forget the master cylinder and prop valve.
|
|
|
|
|
11-18-2023, 08:53 PM
|
#3 |
|
Senior Member
   
Join Date: Jan 2018
Location: Hickory Flat, GA
Posts: 4,421
|
Re: disc conversion
The spindles have different tapers for the ball joints and tie rod ends. 63-70, 71-72, and 73-87 is the differences. Ball joints for all three tapers fit in stock 63-72 and 73-87 arms. Difference in arms is at the control arm bushings. Steel for 63-72, rubber for 73-87.
I’m using 73-87 ball joints in stock 63 control arms on my 63’s disc conversion
__________________
Christian Carpenter 1963 C10 - Frankentruck 283, 3 speed with overdrive Overdrive wiring here1963-ish truck bed trailer - Half-Wit 1981 C10 - Penny 305, th350 1995 Dodge Dakota Sport "I'll put it simple: if you're going hard enough left, you'll find yourself turning right." - Doc Hudson |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
