|
04-20-2011, 04:20 PM
|
#1 |
|
One shot, one kill.
Join Date: Dec 2007
Location: Saratoga Springs NY
Posts: 859
|
Drive shaft woes
Gentlemen:
I usually hang out on the 73 to 87 board. I have recently aquired an 84 S10 long bed pickup with a 4cyl eng and a 4 speed manual trans. It has a wicked vibration at 35MPH. Took the drive shaft out and sent it to the machine shop. Much as I suspected, it's toast. PO had put a new center bearing and U joints in it but that didn't help. I need a 2 piece shaft for this thing. Anyone know where I might aquire such a beast? Thanks, jim
__________________
1984 K20 350M engine with 465,000 miles. Well, it's finally done!! Almost 2 years of work, but it was really worth the effort. Little stuff left to do is mount winch, wet sand & buff out and build belly pan\running boards. Body work takes lots and LOTS of beer!!!! God, Guts and Guns made America and God, Guts and Guns will preserve it! The worst thing you could do is get into my sights, but that don't matter, you'll never know it, cause you'll never hear the shot  Jim or Paladin whichever you choose.
|
|
|
|
04-21-2011, 03:12 PM
|
#2 |
|
Registered User
Join Date: May 2002
Location: VA
Posts: 1,337
|
Re: Drive shaft woes
Junkyard? Or look around for someone parting out a truck. Guess it is two piece because of the longbed...
__________________
69 Chevy C10 88 Sierra 02 2500 Suburban And too many S10s to list! |
|
|
|
|
04-27-2011, 04:25 PM
|
#3 |
|
the boat guy
Join Date: Jul 2007
Location: springfield mo
Posts: 2,339
|
Re: Drive shaft woes
a driveline shop. It's toast? Weld yokes and tube junk also?
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
