Need a Photo np205

[DaHos]

I am in the process of swapping my th350 to a th400 in my 71 k20 and I am looking for pics of the NP205 shifter location in the high hump floor (keeping engine in factory location) The th400 moves it back 3" and not sure of clearance......thx !!

[Blazerowner]

Have you considered moving the engine forward instead. Much less work and usually the holes are in the frame already. If not the t-case handle has to be bent to clear into the stock hole. I’ve seen it done with a 4l80.

[DaHos]

Originally Posted by Blazerowner

Have you considered moving the engine forward instead. Much less work and usually the holes are in the frame already. If not the t-case handle has to be bent to clear into the stock hole. I’ve seen it done with a 4l80.

Was an abandoned project by others, trans crossmember and tc mount have been moved back and driveshifts have been built, was hoping to use what I have........also running a 292 and cannot move engine forward...prob just mod shifter but was looking for ideas......

[sweetk30]

i would make a new bracket / mount for the sifter handle and then a pair of hiem ends and threaded rod for a new link and be done with it .

this is a bit crazy but here is my custom mount for 5 levers . i built it off the top 4 bolts for the round 6 pattern adapter to the 203 range box on the 4l80-e to 241 adapter i used for the doubler .

its just plate and 2 shifter kits from offroad design i modifyed .

#1 - pto pump in/out for hydro winch
#2 - in cab winch control
#3 - 203 range box H/N/L
#4 - rear output of 205 control H/N/L
#5 - front output of 205 control H/N/L

#6 lokar auto trans lever with linkage kit to make it work all the way up were its mounted back to the link point and then down to the trans arm .

[sweetk30]

then when its ready for install i have the floor hump all layed out for the 3 boots . also will be using a stock sm465 shifter boot on the lokar shifter . and with its black shaft it will look like a 4 speed trans shifter .

[HO455]

Originally Posted by sweetk30

then when its ready for install i have the floor hump all layed out for the 3 boots . also will be using a stock sm465 shifter boot on the lokar shifter . and with its black shaft it will look like a 4 speed trans shifter .

Too cool!

[sweetk30]

ya anti-theft kit for gear heads . 6 levers who the heck will figure it all out even with a sticker showing the combo .