|
08-13-2007, 02:04 PM
|
#1 |
|
Texas Big Wig
Join Date: Jan 2007
Location: Mineola, Texas
Posts: 5,620
|
Dropped Cup LCA's
ok guys, here it is
I'm back from see'n my brother & bag'n the front of my truck I took a lot of pics, so I'm not gonna post em all... Here is a link Ima skip the disassembly & start with the good stuff Cut'n the bump stop off   Bolt the upper plate to the bag & mock it up   Made the lower cup     
Last edited by augie; 04-06-2011 at 01:46 AM. |
|
|
08-13-2007, 02:09 PM
|
#2 |
|
Texas Big Wig
Join Date: Jan 2007
Location: Mineola, Texas
Posts: 5,620
|
Re: Lower A-arm ???
Mocked up the lower cup & A-arm, so we could trace where to cut
   Cut'n out   We leveled the cup to the bottom edge of the A-arm   
Last edited by augie; 04-06-2011 at 01:47 AM. |
|
|
|
08-13-2007, 02:15 PM
|
#4 |
|
Texas Big Wig
Join Date: Jan 2007
Location: Mineola, Texas
Posts: 5,620
|
Re: Lower A-arm ???
Drilled a hole it the cross member & put a grommet in for the hose to run through
  Bag installed for good     My temp for airing them up  
Last edited by augie; 04-06-2011 at 01:51 AM. |
|
|
|
08-13-2007, 02:17 PM
|
#5 |
|
Texas Big Wig
Join Date: Jan 2007
Location: Mineola, Texas
Posts: 5,620
|
Re: Lower A-arm ???
Bolting up the lower A-arm
 Putting it all back together      
Last edited by augie; 04-06-2011 at 01:53 AM. |
|
|
|
08-13-2007, 02:23 PM
|
#7 |
|
Texas Big Wig
Join Date: Jan 2007
Location: Mineola, Texas
Posts: 5,620
|
Re: Lower A-arm ???
I couldn't get a pic of it aired out on teh ground, because my brothers air compressor didn't have the umph to get my truck up very high
 But here it is on the trailer   It may go a little lower, but it's sitting on the swivel for the winches hook And it's just about to hit the headers & bind the upper ball-joint Here are some more pics of it at ride & dump... No notch in the rear & no drop spindles   
Last edited by Spray-Bomb; 08-09-2009 at 09:17 PM. |
|
|
 |
| Bookmarks |
|
|
Linear Mode
