|
07-06-2020, 07:07 PM
|
#1 |
|
Registered User
 
Join Date: Apr 2017
Location: Boise, ID
Posts: 856
|
WTB Clutch Linkage
I went under my truck today to adjust the clutch and pulled this part and realized it’s pretty worn. Does anybody have one in better shape laying around?
The threads are stripped, the piece that goes into the clutch fork is pretty worn down, and the piece that goes into the z-bar is about half the original diameter where the z-bar hits it. I was trying to pull the nut off and they’re pretty boogered up, too. Shipping to 95682 please! Thank you all
__________________
1968 GMC C2500 Long Bed Fleetside |
|
|
|
07-07-2020, 03:24 PM
|
#2 |
|
Registered User
Join Date: Apr 2017
Location: Boise, ID
Posts: 856
|
Re: WTB Clutch Linkage
Ttt
__________________
1968 GMC C2500 Long Bed Fleetside |
|
|
|
|
07-08-2020, 11:25 PM
|
#3 |
|
Registered User
Join Date: Apr 2017
Location: Boise, ID
Posts: 856
|
Re: WTB Clutch Linkage
Anybody have one of these? Getting ready to have my dad machine the two pieces for me and using high strength threaded rod with a jam nut on it.
__________________
1968 GMC C2500 Long Bed Fleetside |
|
|
|
|
07-08-2020, 11:29 PM
|
#4 |
|
Senior Member
Join Date: May 2011
Location: Greencastle PA
Posts: 6,695
|
Re: WTB Clutch Linkage
What length do you need
|
|
|
|
|
07-08-2020, 11:44 PM
|
#5 | |
|
Registered User
Join Date: Apr 2017
Location: Boise, ID
Posts: 856
|
Re: WTB Clutch Linkage
Quote:
__________________
1968 GMC C2500 Long Bed Fleetside |
|
|
|
|
|
07-09-2020, 04:29 PM
|
#6 |
|
Registered User
Join Date: Sep 2016
Location: Cypress, Tx
Posts: 79
|
Re: WTB Clutch Linkage
I believe I do
|
|
|
|
|
07-17-2020, 12:46 PM
|
#7 | |
|
Registered User
Join Date: Apr 2017
Location: Boise, ID
Posts: 856
|
Re: WTB Clutch Linkage
Quote:
__________________
1968 GMC C2500 Long Bed Fleetside |
|
|
|
|
|
07-17-2020, 06:11 PM
|
#8 |
|
Senior Member
Join Date: Jul 2018
Location: Vacaville, CA
Posts: 528
|
Re: WTB Clutch Linkage
I will look and see, I thought I had one. But on rod from my clutch pedal to the z-bar / bell crank, I had a worn end and those are hard to come by. Before I bought my welder, I took it down to the local welding shop, had him fill it in with weld and grind down. If I don't have one, give it a shot.
__________________
1971 Custom/10 - 350/3 speed, Orange/White roof |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
