4 wire cruise switch

[A1971Blazer]

Originally Posted by ls1nova71

When you say "factory Blazer", you mean '81-83, not '72, correct? I assume you have one that looks like this.
This is a factory 4 wire switch that was used in the later trucks beforr they went to column mounted dimmer switch columns. It's the only NOS one I have ever had, and before anyone asks, no, it's not for sale.

I don't want to hijack...but I have that same factory switch...
blue, red, green, yellow



my LS1 (2002 F body) is DBC and I have the cruise module from the car
is there a link that shows wiring the cruise module to the pcm?

[ls1nova71]

Originally Posted by A1971Blazer

my LS1 (2002 F body) is DBC and I have the cruise module from the car
is there a link that shows wiring the cruise module to the pcm?

Here you go. http://67-72chevytrucks.com/vboard/s...d.php?t=511477

[A1971Blazer]

Originally Posted by ls1nova71

Here you go. http://67-72chevytrucks.com/vboard/s...d.php?t=511477

Thanks!

[amcgeh01]

Thanks LS1,

My mechanic friend has it currently so I will pick it up in a few days and take some pics.. I also located a highly referred steering column specialist in Anahiem named Felipe of OC Steering and he says he has all the parts I need to make this work.. My friend discovered the bearings are shot so it may need to be rebuilt a the same time.

Originally Posted by ls1nova71

Can you post a pic of what you have? If it's a GM column it should work.

[ls1nova71]

If your lever looks like the one A1971Blazer posted in post#26 then it will work, however most of those levers are only 3 wire and need to be converted to 4 wire.

[A1971Blazer]

Originally Posted by ls1nova71

If your lever looks like the one A1971Blazer posted in post#26 then it will work, however most of those levers are only 3 wire and need to be converted to 4 wire.

This was from your old post...but do you happen to still have any of these labels?

[ls1nova71]

Originally Posted by A1971Blazer

This was from your old post...but do you happen to still have any of these labels?
Attachment 1942695

Yes, I still have them, but your lever looks pretty nice already? PM me if you want more info on them.

[A1971Blazer]

Originally Posted by ls1nova71

Yes, I still have them, but your lever looks pretty nice already? PM me if you want more info on them.

Now that I look more closely at mine...you're right..it's pretty good
putting it on a 50 year old truck...it might look out of place with a nice bright clean label
Thanks for your opinion and your help...!

[ls1nova71]

If you're restoring the whole truck then it may be worth it. In order to use them though, you need to paint the lever black so it doesn't show a difference in colors between the decal and the plastic. I use single stage enamel with gloss hardener and it's dark enough that you cannot tell that it is a sticker, but have put one on an unpainted lever and it looked terrible, way to obvious.

[hemi43]

Originally Posted by amcgeh01

Hi All, really nice to see so much info but apparently my steering column is different.. It's a tilt but when I looked at the turn signal to pull it out, it does not have the set screw that I see in the pics posted, mine screws in...? Does that mean there is no way I can get my mine to work with cruise control for my 5.3 Vortech…? I sure hope I don't have to look for another steering column...

PM sent !! You didn't mention what year engine you had.