|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-17-2002, 12:54 AM
|
#1 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,693
|
1 pc drive shaft info...
Tip....
For a short bed with a short shaft TH350, coil rear, and a small block in the proper location...the drive shaft should be about 4 foot 10 inches long. This measured from center of U-joint cap to center of other cap. |
|
|
|
06-17-2002, 01:20 AM
|
#2 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,693
|
How do i get this on the FAQ board? It oughta go there IMO...
|
|
|
|
|
06-17-2002, 10:51 AM
|
#3 |
|
Unregistered User
 
Join Date: Dec 2001
Location: Houston, TX USA
Posts: 538
|
Thanks Andy. I'm about to swap my engine, and move it up from the 6 cyl location. I wasn't looking forward to trying to measure the length for the new shaft.
__________________
71 SWB Stepside SB400/TH350 |
|
|
|
|
06-17-2002, 10:18 PM
|
#4 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,693
|
Cool, glad I could help.
  One thing I am NOT sure of though, where the shaft goes through the cross member, I'm not sure if the hole is the same size, so it might not be the slam dunk we are thinking. If anyone has info on that, let me know. |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
