|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
12-30-2014, 01:40 AM
|
#1 |
|
Registered User
Join Date: Dec 2013
Location: casselberry
Posts: 37
|
Slammed 6bt suspension
My project is a 63 c10 with a 12v in it and I'm lowering it. I was wondering if anyone had any ideas on the front suspension to get something that will hold the weight?
__________________
63 c10 5.9 cummins |
|
|
|
12-30-2014, 02:50 AM
|
#2 |
|
6>8 Plugless........
 
Join Date: Sep 2007
Location: Prairie City, Ia
Posts: 17,135
|
Re: Slammed 6bt suspension
From what I've seen, the 68-87 stuff holds just fine, and i think they will bolt in your frame. I know guys that had fatman mustang 2 setups and went back to stock type suspensions. I have a 68 vette with a 12v in it and the susension in the front is stock minus aftermarket heavier rated springs. It's held up just fine. If you're going frame laying, maybe forged spindles, tubular control arms to help get the geometry back in check, and good quality ball joints and tie rods etc.
__________________
Ryan 1972 Chevy Longhorn K30 Cheyenne Super, 359 Inline 6 cylinder, Auto Trans, Tilt, Diesel Tach/Vach, Buckets, Rare Rear 4-link and air ride option Build Thread 1972 GMC Sierra Grande Longhorn 4x4 1972 Chevy Cheyenne Super K20 Long Step side tilt, tach, tow hooks, AC, 350 4 speed 1972 C10 Suburban Custom Deluxe 1969 Chevy milk truck 1971 Camaro RS 5.3 BTR STG3 Cam Super T10 1940 Ford 354 Hemi 46RH Ford 9" on air ride huge project Tired of spark plugs? Check this out. |
|
|
|
|
12-30-2014, 08:07 PM
|
#3 |
|
Registered User
Join Date: Dec 2013
Location: casselberry
Posts: 37
|
Re: Slammed 6bt suspension
Thanks. I wasn't sure if the big block springs would hold it up
__________________
63 c10 5.9 cummins |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
