|
06-24-2014, 12:30 AM
|
#1 |
|
Registered User
 
Join Date: Nov 2009
Location: farmington nm
Posts: 178
|
Did i break it
I am currently putting in my motor in my build. got it wired up and was filling to power steering pump when i noticed my electric fans were not working. i do not have a temp gauge hooked up yet. how do i know if i screwed up my motor by running it to hot. 350 cast iron black and heads radiator was full and no coolant boiled out with a 15 psi cap.l
|
|
|
|
06-24-2014, 02:44 AM
|
#2 | |
|
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,403
|
Re: Did i break it
Quote:
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
|
|
|
|
|
06-24-2014, 08:45 AM
|
#3 |
|
Registered User
Join Date: Nov 2009
Location: farmington nm
Posts: 178
|
Re: Did i break it
On and off over 20 minutes. Nothing funky as far as firing. It was idling while I filled the power steering
|
|
|
|
|
06-24-2014, 08:51 AM
|
#4 |
|
Registered User
Join Date: Aug 2009
Location: Bowser
Posts: 13,509
|
Re: Did i break it
Is it a fresh new never run motor or does it have a few miles on it.
If it didn't puke out of the rad it'll be fine. |
|
|
|
06-24-2014, 12:20 PM
|
#5 |
|
Senior Member
Join Date: Jan 2001
Location: Orem, Utah
Posts: 7,791
|
Re: Did i break it
If it ran on an off for 20 minutes, are you sure it even got the coolant temp hot enough to turn the fans on? I doubt you've done any damage at this point.
|
|
|
|
 |
| Bookmarks |
| Tags |
| cooling, hot |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
