85 C10 LT/6L80 Frame off build

[lukeembry]

Originally Posted by SCOTI

I looked @ your build thread on LS1.com. Kind of figured you were going bigger than the L83 since you already had a 6.0.
I highly recommend swapping out your rag-joint set-up for a Cherokee XJ shaft swap. I chimed in on pg.2: http://67-72chevytrucks.com/vboard/s...=505196&page=3

Here’s a pic of the steering shaft I built. stainless 3/4”DD and powder coated 1”DD shafts. Used Borgenson stainless u-joints with the lower having the rubber dampener

[SCOTI]

Originally Posted by lukeembry

Here’s a pic of the steering shaft I built. stainless 3/4”DD and powder coated 1”DD shafts. Used Borgenson stainless u-joints with the lower having the rubber dampener

Looks clean. Hard to beat a clean satin black/SS combo.