|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
02-13-2020, 07:38 AM
|
#1 |
|
Registered User
Join Date: Aug 2015
Location: Ruidoso New Mexico
Posts: 52
|
how to wire 12 volt ignition with stomp starter 1953 chevy truck
Is resistor needed for 12 volt system with points and using the stomp starter ?
Last edited by rustycars63; 02-13-2020 at 07:39 AM. Reason: 235 engine |
|
|
|
02-13-2020, 12:53 PM
|
#2 |
|
Old member
Join Date: Jan 2002
Location: Liberty, & Garden City S.C. , U.S.
Posts: 19,936
|
Re: how to wire 12 volt ignition with stomp starter 1953 chevy truck
I'm not real sure but I would say yes. The resistor wire wasn't stopped being used until the GM HEI was put in vehicles.
__________________
1971 LWB Custom, 6.0LS & 4L80E, Speedhut.com GPS speedometer & gauges with A/C. 20" Boss 338's Grey wheels 4 wheel disc brakes. My Driver Seeing the USA in a 71 Upstate SC GM Truck Club 2013,14 and 2016 Hot Rod Pour Tour http://upstategmtrucks.com/ Get out and drive the truck this summer and have some fun! It sucks not being able to hear! LWB trucks rule, if you don't think so measure your SWB! After talking to tech support at Air Lift I have found out that the kit I need is 60811. Per the measurements I gave them. Ride height of truck inside spring and inside diameter of springs. |
|
|
|
|
02-18-2020, 05:21 PM
|
#3 |
|
Registered User
 Join Date: Oct 2005
Location: Overland Park, Ks.
Posts: 5,190
|
Re: how to wire 12 volt ignition with stomp starter 1953 chevy truck
Yes. A resister is needed. You can use the switch that goes on top of the for 55-59 models. It has a term. on the side that bypasses the resister while the starter is cranking.
George |
|
|
|
|
02-24-2020, 09:57 AM
|
#4 |
|
Registered User
Join Date: Aug 2015
Location: Ruidoso New Mexico
Posts: 52
|
Re: how to wire 12 volt ignition with stomp starter 1953 chevy truck
Thanks for the info.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
