|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-24-2020, 10:34 AM
|
#1 |
|
Registered User
Join Date: Jul 2017
Location: Longmont, Colorado
Posts: 64
|
1972 C10 dome light removal?
PO installed a new dome light kit. Chrome base, clear lenses and all.
Looks nice. Went to install an LED bulb, and found the wires were wrapped around the end of the bulb amd then snapped in? Wth? I want to remedy this and attach the wires to the housing correctly, but how does the housing come off? I see no screws? If it helps, they also installed a cargo light that is powered off the dome light. No manual switch. Dome light comes on, so does the cargo light. Errg!
__________________
1972 C10 LWB 2WD 307 4 speed Rescued from Field July 2017 |
|
|
|
05-24-2020, 02:46 PM
|
#2 |
|
Senior Member
 
Join Date: Mar 2012
Location: Chesapeake, Va
Posts: 1,275
|
Re: 1972 C10 dome light removal?
The chrome plastic base just pops in the truck holes. Pop it out and you can add wires on back of dome assembly.
I have thr cargo light option but i has a separate switch below the dome lighy
__________________
Mike 72 C-10 Cheyenne off frame resto and Upgraded to 4 wheel disk, Tilt, Dakota Digital Dash / Rear slider. 421 SBC / TH350 3000RPM Stall Progression Ignition /Holley 750 DP/3:73 gear Eaton Limited Slip unit / 2 1/2 exhaust glasspacks 
|
|
|
|
|
05-24-2020, 02:47 PM
|
#3 |
|
Senior Member
Join Date: Mar 2012
Location: Chesapeake, Va
Posts: 1,275
|
Re: 1972 C10 dome light removal?
i would use a small toggle switch to control the cargo light and re wire to fuse block
__________________
Mike 72 C-10 Cheyenne off frame resto and Upgraded to 4 wheel disk, Tilt, Dakota Digital Dash / Rear slider. 421 SBC / TH350 3000RPM Stall Progression Ignition /Holley 750 DP/3:73 gear Eaton Limited Slip unit / 2 1/2 exhaust glasspacks
|
|
|
|
|
05-24-2020, 03:07 PM
|
#4 |
|
Registered User
Join Date: Jul 2017
Location: Longmont, Colorado
Posts: 64
|
Re: 1972 C10 dome light removal?
Ok cool. Big mac, I do not want to scratch paint.
Do I just get a plastic trim remover between the housing and steel of the cab and pry off?
__________________
1972 C10 LWB 2WD 307 4 speed Rescued from Field July 2017 |
|
|
|
|
05-26-2020, 06:20 PM
|
#5 |
|
Senior Member
Join Date: Mar 2012
Location: Chesapeake, Va
Posts: 1,275
|
Re: 1972 C10 dome light removal?
Yep u might be able to squeeze the side and pop it off
__________________
Mike 72 C-10 Cheyenne off frame resto and Upgraded to 4 wheel disk, Tilt, Dakota Digital Dash / Rear slider. 421 SBC / TH350 3000RPM Stall Progression Ignition /Holley 750 DP/3:73 gear Eaton Limited Slip unit / 2 1/2 exhaust glasspacks
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
