1972 Blazer - 'Bullet' Project - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Thealien · 09-09-2009, 10:33 AM

I have a motorcycle jack (about $100 at sears) that works great for raising/lowering the gas tank.

When you get the shorter bolts and the tank up where you want it carefull tightening the l bolts that come with the tank/straps. I like things tight and broke the L right off the bolt. Dropped the tank AGAIN welded the bolt better than it ever was and installed the tank AGAIN (I was getting good at it by now.

Good luck

As far as the charcoal cannister, I redid all my lines and rubber hoses and am using it. Venting can't hurt? I still have to go slow filling the tank and my vent line is new, straight, and not kinked?

09-09-2009, 10:33 AM	#10
Thealien Senior Member Join Date: Jun 2007 Location: Pine Ridge Florida Posts: 4,120	Re: 1972 Blazer - 'Bullet' Project I have a motorcycle jack (about $100 at sears) that works great for raising/lowering the gas tank. When you get the shorter bolts and the tank up where you want it carefull tightening the l bolts that come with the tank/straps. I like things tight and broke the L right off the bolt. Dropped the tank AGAIN welded the bolt better than it ever was and installed the tank AGAIN (I was getting good at it by now. Good luck As far as the charcoal cannister, I redid all my lines and rubber hoses and am using it. Venting can't hurt? I still have to go slow filling the tank and my vent line is new, straight, and not kinked?



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.