"Basics of Basics" rebuilding hinges. - The 1947 - Present Chevrolet & GMC Truck Message Board Network

MARTINSR · 10-11-2007, 10:05 AM

I only replaced the top hinges bushings. I simply knocked out the pin, leaned the door over on a floor jack with a 2x4 on top. I busted up the bushings with a small, sharp chisel until the pieces just fell out. I could have done both top and bottom this way but the bottom was barely loose. After replacing the top, the door worked almost perfect and I stopped there instead of doing the bottom too.

You can see in the bottom photo how the door side of the hinge is right there in the picture. So the space is a little cramped but do-able.

Brian

10-11-2007, 10:05 AM	#6
MARTINSR Registered User Join Date: Dec 2000 Location: Boise, Idaho Posts: 6,003	Re: "Basics of Basics" rebuilding hinges. I only replaced the top hinges bushings. I simply knocked out the pin, leaned the door over on a floor jack with a 2x4 on top. I busted up the bushings with a small, sharp chisel until the pieces just fell out. I could have done both top and bottom this way but the bottom was barely loose. After replacing the top, the door worked almost perfect and I stopped there instead of doing the bottom too. You can see in the bottom photo how the door side of the hinge is right there in the picture. So the space is a little cramped but do-able. Brian __________________ 1948 Chevy pickup Chopped, Sectioned, 1953 Corvette 235 powered. Once was even 401 Buick mid engined with the carburetor right between the seats! Bought with paper route money in 1973 when I was 15. "Fan of most anything that moves human beings"



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.