85 C10 LT/6L80 Frame off build

[MHarvey]

Looks awesome Luke. I’m looking forward to seeing it around town and hopefully at LS Fest

[melks]

Just awesome man! What are the specs on the exhaust pipes? Love the subtle factory style...

[lukeembry]

Originally Posted by melks

Just awesome man! What are the specs on the exhaust pipes? Love the subtle factory style...

Thanks, the exhaust is Hooker C10 swap 2.5" exhaust in 304 Stainless

several options available

https://www.holley.com/products/engi...ap_components/

[lukeembry]

Originally Posted by rodstored-72

"...sooooooo nice..."

"...... +1.."

this only begins to describe this build!! this is a very beautiful and well detailed build!!
Luke, congrats on getting to drive it at last!!

Originally Posted by Mattchu60

I'm impressed by this build. Truly top notch work and the end result is incredible.

I'm also impressed with the speed of the build - you went from primer to a completed truck in less than 2 months!

Originally Posted by Gotenntitans

Superb looking truck!!!

Originally Posted by LT7A

Totally enjoyed following this. And like watching a good movie, I'm bummed it's finished, ha! Glad that you get to enjoy it and I hope that you'll show us pics of it out and about and any more updates. Most of us can only dream of having a truck this nice so don't end the movie yet!

Originally Posted by SCOTI

Sooooooooooooooooo nice!

Originally Posted by Hart_Rod

+1!

Thanks guys, hang around I'll post up more pics

[87chevy.com]

The alternator wire isnr getting warm.is it? Hard to tell how beefy it is but I installed some stock Camaro e fans on a build and that wire happend to be to small. Another note, is that a new 4 core rad support bracket? If so where did you source it from?
Fantastic build!

[lukeembry]

Originally Posted by 87chevy.com

The alternator wire isnr getting warm.is it? Hard to tell how beefy it is but I installed some stock Camaro e fans on a build and that wire happend to be to small. Another note, is that a new 4 core rad support bracket? If so where did you source it from?
Fantastic build!

its a 4 ga wire so no worries there, the radiator cover is from LMC.

[rodstored-72]

luke,
Thanks again for sharing this build. I re-read the thread again & did not see what you did for your trans linkage? would you be willing to share how you connected the trans to the steering column (in relation to shift linkage)?
Also I was wondering if you would share what wires on your firewall block (truck) you are using on the engine portion to the LS? I would like to know what wires you used from the truck part of the harness?

thank you again & I am following along on the blazer build too!!