Cab and door body work In order

[chewychevy67]

I am reskining both my doors and they need some work on the Inside. Should all that work be competed before I do the cab so when I do the rockers they can be aligned with the doors?

[chewychevy67]

Also a guy I was talking with said he sandblasts cabs. Seems to me this might warp stuff. Is that a common practice?

[nsb29]

Get your doors dun first but I would check the skin fit with your opening as you go then do rockers

[nsb29]

Originally Posted by chewychevy67

Also a guy I was talking with said he sandblasts cabs. Seems to me this might warp stuff. Is that a common practice?

Sandblasting is a good way to prep your cab but if you don’t know what you’re doing its also a good way to screw it up you have to be carful with the large panels the rest of the cab you don’t have any problem with

[chewychevy67]

Ok. My cab will be getting a new floor put in it so I assume it should be the very 1st step. Then do the doors and then do the rest of the bottom of the cab

[88fordf150]

Do your doors first then the outer rockers. I did my rockers first and now they are off about 1/4". I have to cut them out a reset them so they fit right. Lesson learned.