|
08-26-2019, 11:01 AM
|
#1 |
|
Registered User
Join Date: May 2019
Location: NRH, Texas
Posts: 17
|
Hub Bore for 65 C10
Does anyone know what the hub bore needs to be for stock sized six lug drums on my 65 (front and rear) ? My truck is about 2 hours away so I can't measure myself until I run down this weekend. It's sitting in the barn with 4 flats so I'd like to get the aluminum wheels I've got ready to go since I've got a fresh set of tires for those.
Thanks! |
|
|
|
08-26-2019, 11:45 AM
|
#2 |
|
Registered User
Join Date: Feb 2012
Location: Beautiful BC, Canada, eh?!
Posts: 2,182
|
Re: Hub Bore for 65 C10
2wd 5-bolt should be 78.3mm.
This thread suggests a fart over 3.5", which sounds aboot right. Rock Auto says the hole in the brake drum is 3.57" Rock Auto is a wealth of information when you need it.
__________________
1961 Apache: "Grabber Orange" Shortboxed, pancake, step-notch, air-ride, boosted-LS 1977 Silverado: Shortboxed & dropped, potato-potato V8 Pontiac Firefly (Chevy Sprint): The ultimate engine swap: 5.7L in a 1.0L bag Lotus Super 7 Replica: Scratch-built street-legal rollerskate Last edited by SkinnyG; 08-26-2019 at 11:51 AM. |
|
|
|
|
08-26-2019, 01:11 PM
|
#3 |
|
Registered User
Join Date: May 2019
Location: NRH, Texas
Posts: 17
|
Re: Hub Bore for 65 C10
Awesome thank you.
|
|
|
|
|
08-26-2019, 07:45 PM
|
#4 |
|
Registered User
Join Date: Sep 2016
Location: Ft Smith, AR
Posts: 544
|
Re: Hub Bore for 65 C10
Had a spare drum in my garage. 3.57" is correct.
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
