72 2wd project "No Daggum Money"

[jjzepplin]

So Will a 67 GMC hood fit the 67 Chevy front clip?

[lolife99]

Originally Posted by jjzepplin

So Will a 67 GMC hood fit the 67 Chevy front clip?

yes

[jjzepplin]

Thanks for the reply. I may have found one. Says no rust etc but GMC not Chevy. Last one I drove a long way to find the "no Rust" was actually holes you could see right through the top of the hood. So we will see. I think this time I will ask for lots of pics before making the journey.
So just take off the GMC letters and that should be it?

[colgad]

Originally Posted by jjzepplin

Thanks for the reply. I may have found one. Says no rust etc but GMC not Chevy. Last one I drove a long way to find the "no Rust" was actually holes you could see right through the top of the hood. So we will see. I think this time I will ask for lots of pics before making the journey.
So just take off the GMC letters and that should be it?

You are alive!!! :-)
Yea, that GMC hood is the same, weld up the holes and your good!!!

Currently starting to put a 6.0 LS style engine in my red short bed.

[jjzepplin]

I thought that one was finished?

[colgad]

Originally Posted by jjzepplin

I thought that one was finished?

It was, but I am very tired of the constant carb issues. It sits for weeks and when I want to drive it there is always something keeping me from doing it.
So I am currently working on the factory harness getting it ready to put the 6.0L on the test stand.

[jjzepplin]

What carb does it have? Edelbrock? I think my Holley does a good job and does not give me troubles, I will eventually go with a bolt on injection system. This way I get injection-and a big small block.
I have been out of it for a while as I have had to fix My Air conditioning- My wife's A/C and the house A/C. Now I know a bunch about A/C! My wife's car and mine can get below zero! My house can easily get below 70. I need to reseal all my ducting and it will get even better.
I am going to take all the old parts from my wife's Toyota and make it fit in my heater box for the Blazer-Hook it up to the new SD508 and we should be frozen out pretty quick.
Old Yeller has the GM R4 and seems to be in good condition so I will give it a shot with the parrallel condenser after a good flushing of the stock parts and calibration of the POA. Just have to find out how much oil goes in the system. Should be about the same as a 92 Caprice or P/U.