|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
09-27-2006, 11:23 PM
|
#1 |
|
Registered User
Join Date: Jun 2004
Location: Saskatchewan, Canada
Posts: 1,368
|
Finally installed my carpet and other seat.
Well it's in, took me long enough but i got it installed along with new gas, brake, e-brake covers and radio delete.
__________________
Speed is just a matter of money, question is how fast can you afford to go? 8.95@148.97mph all motor haven't tried bottle yet Sponsored by: Getz Oilfield Consulting Hard Candy Customs |
|
|
|
09-27-2006, 11:24 PM
|
#2 |
|
Registered User
Join Date: Jun 2004
Location: Saskatchewan, Canada
Posts: 1,368
|
Re: Finally installed my carpet and other seat.
Couple more for good measure.
__________________
Speed is just a matter of money, question is how fast can you afford to go? 8.95@148.97mph all motor haven't tried bottle yet Sponsored by: Getz Oilfield Consulting Hard Candy Customs |
|
|
|
|
09-28-2006, 12:12 AM
|
#3 |
|
Registered User
Join Date: Dec 2003
Location: Glendale Arizona
Posts: 747
|
Re: Finally installed my carpet and other seat.
Looks really clean. Nice work. What did you use to hold that radio cover on?
__________________
"A true hotrodder wouldn't be content untill he had created a car so violent, so hairy, so totally sick that the very act of dropping the hammer would result in instant death. Anything less results in the need to go faster." - Tony DeFeo |
|
|
|
|
09-28-2006, 12:14 AM
|
#4 |
|
Registered User
Join Date: Jun 2004
Location: Saskatchewan, Canada
Posts: 1,368
|
Re: Finally installed my carpet and other seat.
Good old 3M double side trim tape.
__________________
Speed is just a matter of money, question is how fast can you afford to go? 8.95@148.97mph all motor haven't tried bottle yet Sponsored by: Getz Oilfield Consulting Hard Candy Customs |
|
|
|
|
09-28-2006, 02:06 AM
|
#5 |
|
Registered User
Join Date: May 2005
Location: Beaverton, OR
Posts: 3,728
|
Re: Finally installed my carpet and other seat.
Very sweet indeed! Running in the 10's would be nice!
|
|
|
|
|
09-28-2006, 04:04 AM
|
#6 |
|
Epoxy Primer Friendly
Join Date: Feb 2004
Location: South of Houston TEXXXAS
Posts: 680
|
Re: Finally installed my carpet and other seat.
Is the shoulder harness mounted to the floor or the rollbar right behind the seat ? If the floor, please move them as this is suppose to be a safety hazard and could cause too much pressure on your back by pulling down and not back crushing your spine, in a wreck. Do some research or ask some chassis builders if you need some justification.... LOOKS GOOD THOUGH
Last edited by camaro__thunder; 09-28-2006 at 04:05 AM. |
|
|
|
|
09-28-2006, 09:43 AM
|
#7 |
|
Registered User
Join Date: Jun 2004
Location: Saskatchewan, Canada
Posts: 1,368
|
Re: Finally installed my carpet and other seat.
Roll bar mounted for sure, all done by chassis builder, passed by NHRA chassis inspector.
 If mounted to the floor, go around the bar then through the seat, but to the bar is best by far, like you said NEVER go just from the floor.
__________________
Speed is just a matter of money, question is how fast can you afford to go? 8.95@148.97mph all motor haven't tried bottle yet Sponsored by: Getz Oilfield Consulting Hard Candy Customs Last edited by 71Dragtruck; 09-28-2006 at 09:46 AM. |
|
|
|
|
| Bookmarks |
|
|
My Project 69 SWB
Linear Mode
