|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
08-09-2014, 12:47 PM
|
#1 |
|
Registered User
Join Date: Jul 2013
Location: Conyers, GA
Posts: 29
|
Routing for Door Jamb Switch Wires?
I've started installing/re-installing my wiring harness. Thanks to a lack of pictures and short-term memory, I don't remember how to route the door jamb switch wires from the inside of the cab to the door frame
 . Can anyone share some pics or wisdom on this?Also, if you've used a painless harness in your truck, did it come with the dome/cargo lamp harness? If it does, then I can add that to the list of things I've lost as well. Thanks, David
__________________
David Next project - 1953 Chevy 150 2 Dr Sedan. https://www.chevytalk.org/fusionbb/s...hp?tid/355913/ |
|
|
|
08-09-2014, 06:15 PM
|
#2 |
|
Senior Member
 
Join Date: May 2010
Location: Wisconsin & Arizona
Posts: 4,839
|
Re: Routing for Door Jamb Switch Wires?
The pictures below show how they go through the kick panels. Driver side is top, passenger side is bottom. Both sides originally had grommets.
|
|
|
|
|
08-10-2014, 08:50 AM
|
#3 |
|
Registered User
Join Date: Jul 2013
Location: Conyers, GA
Posts: 29
|
Re: Routing for Door Jamb Switch Wires?
Thank you, FirstOwner! I'll run to the hardware store and see if I can find something to use as the grommet.
David
__________________
David Next project - 1953 Chevy 150 2 Dr Sedan. https://www.chevytalk.org/fusionbb/s...hp?tid/355913/ |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
