MD WTB Blazer repair parts

[richard2717]

I need both rocker boxes, end plates, rocker panels, floor pans and some rear tub floor sections around the wheel tubs for my 71 k5. anybody got some good used stuff or extra new stuff that fits good?

thanks
Richard

[richard2717]

I found some rocker box ends but still looking for most everything else. Getting ready to start teardown soon so if no one has any good used I guess I will bite bullet and buy new.

[jeffg1010]

Can you show me which sections you need? I am parting out a blazer and the floors are decent. I have a complete parts thread in the blazer parts section if you would like to see photos

http://67-72chevytrucks.com/vboard/s...=500099&page=5
Posted via Mobile Device

[richard2717]

Jeff
pending shipping and condition of bottom side of floor area I would be interested in the rear floor area that I circled red ( large circle) the small circles are of the questionable areas, is that rust thru? How is the bottom side of the panel?

I don't care if you have to cut it down for shipping. I think the biggest box for ups before it get crazy is 72"x20"x8"

I would also be interested in the outside pass. door handle if available & in good condition.

Thanks
Richard

[jeffg1010]

Yeah, overall... if you needed the large piece there are some through wall holes. I dont think I have a pic of the underside, but I can get you one this week.

You may want to look through the photobucket link for the Blazer parts. There is 148 photos. You may see something else you are looking for
http://s213.photobucket.com/albums/c...arts%20Blazer/

[richard2717]

Basically what I need is the area around the wheel tubs out about 6" or so, but I figured I would take the plasma and mig and make my own if I could get enough floor sections. Let me know what you need for it shipped to business 21826. Like I said earlier you could cut it up in enough pcs that it could fit in a 20'x 72" box for ups and it should still be reasonable enough to ship ( I think)

Richard