The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > Info Center > FAQ Truck Tech > 60-66

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 09-17-2016, 02:17 PM   #1
whitley7
Registered User
 
Join Date: Jul 2014
Location: farmville nc
Posts: 16
63 C10 - Need info on upgrading to power brakes Currently have disc/drums

Hi everyone, I got this truck last year as a rolling chassis. The previous owner had install disk brakes on the front and ran new brake lines. I have since put in a 350 w/ a th350, new radiator, battery, driveshaft, dual exhaust, tires and rims. During this process I have discovered that the lug pattern is not original (5 x 5.5 vs 6) that the champion aluminum radiator sold on eBay is not a direct fit and having a solid driveshaft fabricated is expensive.

I was finally able to drive her last week and immediately notice that the brakes are terrible. It does stop, but it takes a lot of pressure and I don't think I could lock the brakes up if I really tried. I did notice after getting back home that the outside of the master cylinder looked oily, but it didn't look like it leaked everywhere. Maybe the top is allowing fluid to leak out? Anyway, I decided that my next project for her should be upgrading to power brakes. I have read the faq section, but haven't found what I'm looking for. I have seen that I can by a kit online for this upgrade, but being a father of 4 necessitates that I do this as low cost as possible. This is my first project ever and I don't know a great deal about mechanic work (YouTube is my best friend). I'm amazed at the knowledge of members on this site. Anyway, I would like to get the booster and master cylinder from a pull a park yard not far from my house, but I'm not sure what will work (years, models etc). Also, since the PO has upgraded the brake lines, would I be able to use the current proportioning valve? What modifications would I need to make to the brake pedal? I had to buy a front caliper cause the previous one was locked up and found I had to get one for a 71 truck to match. Does that matter?

I'm gonna post pics of my truck any insight would be greatly appreciated as I don't know what's original and what isn't. I hope to move the gas tank to the rear at some point. Replace the Column and steering wheel to get the shifter the previous owner put in the floor back on the column and for more room.

Sorry for the long post. Any help/ info would be greatly appreciated. Thanks in advance.
Attached Images
 
whitley7 is offline   Reply With Quote
Old 09-17-2016, 02:29 PM   #2
whitley7
Registered User
 
Join Date: Jul 2014
Location: farmville nc
Posts: 16
Re: 63 C10 - Need info on upgrading to power brakes Currently have disc/drums

Sorry, I can only attach one image per post. More to follow.
Attached Images
 
whitley7 is offline   Reply With Quote
Old 09-17-2016, 02:30 PM   #3
whitley7
Registered User
 
Join Date: Jul 2014
Location: farmville nc
Posts: 16
Re: 63 C10 - Need info on upgrading to power brakes Currently have disc/drums

Another photo.
Attached Images
 
whitley7 is offline   Reply With Quote
Old 09-17-2016, 02:32 PM   #4
whitley7
Registered User
 
Join Date: Jul 2014
Location: farmville nc
Posts: 16
Re: 63 C10 - Need info on upgrading to power brakes Currently have disc/drums

Master cylinder
Attached Images
 
whitley7 is offline   Reply With Quote
Old 09-17-2016, 02:34 PM   #5
whitley7
Registered User
 
Join Date: Jul 2014
Location: farmville nc
Posts: 16
Re: 63 C10 - Need info on upgrading to power brakes Currently have disc/drums

Some more.
Attached Images
 
whitley7 is offline   Reply With Quote
Old 09-17-2016, 02:40 PM   #6
whitley7
Registered User
 
Join Date: Jul 2014
Location: farmville nc
Posts: 16
Re: 63 C10 - Need info on upgrading to power brakes Currently have disc/drums

Another
Attached Images
 
whitley7 is offline   Reply With Quote
Old 09-17-2016, 02:45 PM   #7
whitley7
Registered User
 
Join Date: Jul 2014
Location: farmville nc
Posts: 16
Re: 63 C10 - Need info on upgrading to power brakes Currently have disc/drums

Another
Attached Images
 
whitley7 is offline   Reply With Quote
Old 09-17-2016, 02:50 PM   #8
whitley7
Registered User
 
Join Date: Jul 2014
Location: farmville nc
Posts: 16
Re: 63 C10 - Need info on upgrading to power brakes Currently have disc/drums

Another picture
Attached Images
 
whitley7 is offline   Reply With Quote
Old 12-30-2018, 10:33 PM   #9
keepinitgoin
Registered User
 
Join Date: Nov 2016
Location: Phoenix, Desert Hills, AZ
Posts: 7
Re: 63 C10 - Need info on upgrading to power brakes Currently have disc/drums

Your rear brake hose to the T fitting looks like it is rubbing on your right exhaust pipe. Not good, needs to be routed away from the tail pipe!!
__________________
keepinitgoin is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 01:33 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.
Copyright 1997-2013 67-72chevytrucks.com