The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > General Truck Forums > Engine & Drivetrain > LSx Swaps

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 09-08-2020, 12:01 AM   #1
Arnulfo
Registered User
 
Join Date: Aug 2015
Location: Los angeles
Posts: 159
4L65E transmission

Greetings, i got this transmission out of a all wheel drive vehicle along with the LQ9 that it was attached to. I plan on installing both into my C20. I think i need to change the output shaft and the tail housing. Is there anything else i need to do to it to make it work in my 2 wheel drive C20? Thanks for the info
Arnulfo is offline   Reply With Quote
Old 09-10-2020, 04:45 PM   #2
AussieinNC
Moderator
 
AussieinNC's Avatar
 
Join Date: Jun 2017
Location: Cherryville, NC
Posts: 2,152
Re: 4L65E transmission

Output shaft and tail housing needed...trans must come fully apart...good time to reseal it etc...there are several threads about overhauling 4l65E units...

Consider what type of speedo you will be using...digital from the factory sensors or manual or GPS based????

What trans controller are you intending on using?

__________________
Family and country before all others...

2006 Chevy Silverado (Daily Driver)
2012 Chevy Equinox

AussieinNC is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 03:01 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com