The 1947 - Present Chevrolet & GMC Truck Message Board Network

Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > General Truck Forums > Suspension


Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 08-03-2020, 09:57 PM   #1
Registered User
Join Date: Oct 2012
Location: WA
Posts: 119
Caliper misalignment

New installation of Wilwood D52 calipers on the front of my '69 C10. Using ECE's spindles for the disc brake conversion.

How much misalignment is acceptable of the caliper to rotor?

Not sure about the OEM version of these but Wilwoods have a sleeve that the caliper body slide on. The o-rings between the caliper body and the sleeve were damaged upon installation and I will buy new ones. I flipped them around and regreased them and they slide pretty easy but the drivers side is off by .010 ? Only about 20% of the pad shows wear from turning the rotor by hand. My rotor is about .008-.010" to big for my caliper and pads but am going to check them after doing a few 40-0 stops. Both rotors turn by hand but this one with the misalignment is tough.

I took off about .015" ( measured ) of material from the top mounting surface for the caliper on the mount to get the alignment what I thought was correct before I put fluid in the new brake system. I could shim it back but I dont see how it would change anything... I lightly pryed on the caliper to see if shimming would help but at best I could almost get it be aligned but I didn't want to use much force.

Any ideas?

My main concern is with rotor already bigger than it should be that the misaligned caliper will act differently and maybe cause pulling to one side while driving... Thank you for any help.
Baker819 is offline   Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -4. The time now is 01:03 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.
Copyright 1997-2020