CA 60-66 extra small stuff lots of it

[tchevs]

Originally Posted by LostMy65

Do you know if the water temperature sensor works and is for our generation trucks?

I was looking at the pictures but can’t see a temperature sender on it. The sensors that I see are oil pressure and are for our trucks that have dummy lights instead of gauges. If I’m not mistaken there is two types of senders for our truck temperature. The one for gauges and the one for lights. The one for lights has two prongs to connect to, usually light green and dark green wires hooked to it. If you had gauges the connection is like a small button that your connection with green wire would connect to. Depending on what cluster a vehicle came with lights or gauges both sensors are common to all Chevy vehicles. Very long answer to (any junkyard V8 or straight six).

[LostMy65]

It's in the red circle.
My truck had gauges.

[tchevs]

Originally Posted by LostMy65

It's in the red circle.
My truck had gauges.

What an eye. Yes it’s in there, not sure of its operation. I would be able to test it if I knew the ohms rating it supposed to be.

[LostMy65]

I found this, but I wouldn't know how to test it. Maybe put it in different temperature's of hot water and see if the ohms are at those temps.
I don't expect you to go through all that. I figured if you knew that it was correct I'd be interested.

[tchevs]

That temp sensor is no good according to that chart. Cold or hot

[LostMy65]

Originally Posted by tchevs

That temp sensor is no good according to that chart. Cold or hot

Ok, thanks for checking.

[Joe P]

Originally Posted by tchevs

Hey Joe
Sick5 didn’t respond so you’re next in line. It would probably fit in a flat rate envelope, if you’re ok with it in an envelope let’s do $40 shipped to you, to cover shipping and PayPal.

Tony

Received the parts yesterday, good stuff, good packing, fast shipment! Thank you!

[Joe P]

Originally Posted by Joe P

Received the parts yesterday, good stuff, good packing, fast shipment! Thank you!

Tony, any chance you have un-rusted cab mounts that look like the attached photos? My frame is a 1966 K20

[tchevs]

These are 68 front look very similar clean yours up a bit see if you agree. Than we can measure the dimensions

[tchevs]

Ttt

[Johns 66]

Do you have a waterpump bypass valve? Also do you have any front suspension bolts to bolt cradle to the frame

[tchevs]

Hello marine

I don’t have either of the parts you are looking for.

[Lokin4AReason]

Any fotos of the jack hardware ?

[tchevs]

Originally Posted by Lokin4AReason

Any fotos of the jack hardware ?

The only photo I have at the moment is post 3 part number 27. If that is the parts you are after I can dig them out and get close ups.

[Johns 66]

Originally Posted by tchevs

Hello marine

I don’t have either of the parts you are looking for.

Thanks Brother for checking