|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-21-2023, 03:39 PM
|
#1 |
|
Registered User
Join Date: Dec 2016
Location: Lyon, MI
Posts: 69
|
60-62 Rolling Short Frame
As pit free a frame as you will find. The front cab mounts (for 63-66 cab) have been welded on, and some repair has been done on the lower bumper mount (still fits 60-62 bumper). Cut for fuel filler hose. Welded at pass side above axle. Has a maybe later truck 12 bolt (cast 3817769). Rolling on 2008ish wheels, center holes cut to fit.
Start with a solid frame, Porterbuilt makes a ton of suspension stuff for these. $400 for the rolling frame |
|
|
|
04-21-2023, 03:45 PM
|
#2 |
|
Registered User
Join Date: Dec 2016
Location: Lyon, MI
Posts: 69
|
Re: 60-62 Rolling Short Frame
more pics
|
|
|
|
|
04-21-2023, 03:47 PM
|
#3 |
|
Registered User
Join Date: Dec 2016
Location: Lyon, MI
Posts: 69
|
Re: 60-62 Rolling Short Frame
couple more
|
|
|
|
|
04-21-2023, 10:14 PM
|
#4 |
|
Senior Member
   
Join Date: Jan 2018
Location: Hickory Flat, GA
Posts: 4,421
|
Re: 60-62 Rolling Short Frame
The rear axle could be a 63-64 axle based on the trac bar mount. Does it have bolt on backing plates for the brakes?
__________________
Christian Carpenter 1963 C10 - Frankentruck 283, 3 speed with overdrive Overdrive wiring here1963-ish truck bed trailer - Half-Wit 1981 C10 - Penny 305, th350 1995 Dodge Dakota Sport "I'll put it simple: if you're going hard enough left, you'll find yourself turning right." - Doc Hudson |
|
|
|
|
04-22-2023, 09:16 PM
|
#5 |
|
Registered User
Join Date: Dec 2016
Location: Lyon, MI
Posts: 69
|
Re: 60-62 Rolling Short Frame
Looks like the backing plates are welded or pressed from the back side.
Also the trailing arms look a little wide for the axle |
|
|
|
|
04-23-2023, 06:00 PM
|
#6 |
|
Senior Member
Join Date: Jan 2018
Location: Hickory Flat, GA
Posts: 4,421
|
Re: 60-62 Rolling Short Frame
Yup, that's most likely a 63-63 truck 12 bolt. The 60-62 frames had a wider spacing for the trailing arms, so when an axle is used from a 63-72 truck, most people just weld new perches to the axle right next to the original perches
__________________
Christian Carpenter 1963 C10 - Frankentruck 283, 3 speed with overdrive Overdrive wiring here1963-ish truck bed trailer - Half-Wit 1981 C10 - Penny 305, th350 1995 Dodge Dakota Sport "I'll put it simple: if you're going hard enough left, you'll find yourself turning right." - Doc Hudson |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
