|
02-26-2008, 07:14 AM
|
#1 |
|
Registered User
Join Date: Jun 2007
Location: oregon
Posts: 1,069
|
door differences
I know i have read about this before....................my truck has one original door for it's 69 cab... the other door is from a 71 i believe and it has a dimple and a hole adjacent to the wind wing area on the inside of the door top edge kinda right below the wing arera. Can this hole and dimple be filled??
Thank you
__________________
69 K-20 cloned to a 67 with front clip and some other stuff. 383 .040 over Crane roller cam lifters and rockers ,1.6 intake ratio, Open chamber heads, 9.5-1 compression ratio, 2.02 intake valves , Edelbrock performer Air Gap manifold Carter AFB performer 750cfm, MSD ignition, SM465 NP205 4.10 gears: 
|
|
|
|
02-26-2008, 03:03 PM
|
#2 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: door differences
The door with the hole at the vent window is a 72. If you fill the hole you will need to make sure of the brace in the area, (look in your 69 door as it will have a flat piece of sheet metal that connects the two halves of the door).
67-71 doors had cracking problems in the connection allowing the door to spread so the screw was added in 72 to cure the problem. Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
