|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-12-2009, 09:03 PM
|
#1 |
|
Registered User
 
Join Date: Jan 2005
Location: Illinois
Posts: 1,006
|
Removing 700R4 Shifter Rod
I am trying to remove the shifter rod in my 700R4 tranny. I removed the manual detent spring, 5/8 nut off the shifter rod and the shaft retainer. I just cant get the inside detent lever to seperate off of the shifter shaft. Any ideas??
|
|
|
|
04-12-2009, 09:22 PM
|
#2 |
|
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
Re: Removing 700R4 Shifter Rod
wack it gently wth a hammer
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY |
|
|
|
|
04-12-2009, 09:39 PM
|
#3 |
|
Registered User
Join Date: Jan 2005
Location: Illinois
Posts: 1,006
|
Re: Removing 700R4 Shifter Rod
I tried to put a set of vise grips on the outside portion of the shaft and tap it out, but it never moved
|
|
|
|
|
04-13-2009, 04:21 PM
|
#4 |
|
Registered User
Join Date: Jan 2005
Location: Illinois
Posts: 1,006
|
Re: Removing 700R4 Shifter Rod
Mission Complete!!
|
|
|
|
|
04-19-2009, 02:29 PM
|
#5 |
|
Registered User
Join Date: Jan 2005
Location: Illinois
Posts: 1,006
|
Re: Removing 700R4 Shifter Rod
Well it is installed, but now a new problem. The new shifter lever didn't have a nut on it. I bought both a fine threaded nut and course nut and neither will start on this shaft. Is there anything special about these shafts? Anyone know the pitch of the threads?
Last edited by 1971ChevyTruck; 04-19-2009 at 02:29 PM. |
|
|
|
|
04-19-2009, 02:43 PM
|
#6 |
|
Registered User
Join Date: Jan 2005
Location: Illinois
Posts: 1,006
|
Re: Removing 700R4 Shifter Rod
I think I just found my answer...I think its a 10mm 1.5 nut. Am I right??
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
