|
04-16-2016, 12:45 PM
|
#1 |
|
Registered User
Join Date: Nov 2015
Location: Jemison, Al.
Posts: 201
|
69 c-10 fender emblem
Guys I need a little help. The PO of my truck took out the emblems and welded the holes up, not sure why but its done. Can one of you possibly give me some pics or measurements for me to relocate and install these. Sounds like a good Saturday afternoon project.
Also, I think I will have to take loose the inner fenders to accomplish this but not sure. Headed out there in a bit to wee what is going to be involved. Any tips??? |
|
|
|
04-16-2016, 01:32 PM
|
#2 |
|
Registered User
 Join Date: May 2014
Location: Pittsburgh, PA
Posts: 712
|
Re: 69 c-10 fender emblem
I don't know if this will help or not. I took these measurements from an original fender. The measurements from the top were taken with one of those soft, cloth measuring tapes and taken from the top edge of the fender. No guarantees these are correct, but it's what I went with
__________________
Bill 2004 Chevy Silverado Z71 Ext Cab 1500 1972 Chevy K-10 SOLD 1967 Chevelle SS |
|
|
|
|
04-16-2016, 01:40 PM
|
#3 |
|
Registered User
Join Date: Nov 2015
Location: Jemison, Al.
Posts: 201
|
Re: 69 c-10 fender emblem
Thanks, mine just has the c-10 not the custom so its much shorter. The height should be the same I would think, so I may be able to get it from there.
|
|
|
|
|
04-16-2016, 01:45 PM
|
#4 |
|
Registered User
Join Date: Nov 2015
Location: Jemison, Al.
Posts: 201
|
Re: 69 c-10 fender emblem
Well that fooled me. The c/10 emblem has the exact center post measurement. Thank you sir, that helped a lot.
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
