Blazer half cabs

[truckeez]

Originally Posted by Pjay3000

Hey if you could give me a call sometime 480-695-6728 I want to see what's on volved I'm getting at half cab thanks

Well this 76-91 version is pretty much the same as, you get a sheetmetal shop to fab the lower bedwall, get 4 buddies to come over and remove the heavy factory one, and simply bolt in the custom stuff,
(you mask off the floor and wax it and set the bedwall in place temporarily set upward slightly lile 1/32 " pump in scilicone to form the lower bedwall gasket~ clean away excess Tidy-ly)

and once its set up yo then bolt the bewall in place, it seals -But is not stuck to the floor.

[truckeez]

Originally Posted by truckeez

Well this 76-91 version is pretty much the same as, you get a sheetmetal shop to fab the lower bedwall, get 4 buddies to come over and remove the heavy factory one, and simply bolt in the custom stuff,
(you mask off the floor and wax it and set the bedwall in place temporarily set upward slightly lile 1/32 " pump in scilicone to form the lower bedwall gasket~ clean away excess Tidy-ly)

and once its set up yo then bolt the bewall in place, it seals and is not stuck to the floor.

This rear walls lower edge turns back on a 76-91 style, on the 69-72 if goes forward

[Zsanders]

Hey everybody, new to the group. I have a Pacesetter half cab and I’m looking for a bulkhead or a diagram so I can build one. I’ll try and add a pic of my 71 2wd with the half cab on it.

Thanks
Zac