72 c10 steering gear box - The 1947 - Present Chevrolet & GMC Truck Message Board Network

gimpie01 · 10-18-2013, 12:23 PM

Help'
I replaced the input shaft seals(leaking) and now the steering is extermely difficult to turn. It seems as though the rag joint is rubbing against the adjuster with the set bolt, everything appears to be in place.HELP !!!!

hugger6933 · 10-18-2013, 09:57 PM

Have you tried to take the shaft loose [ from the steering side] to try to turn the box again? How far into the box did you go? Do you think any of the balls in the worm could have gotten out of place? That would leave you with a hard to turn box if you could turn it. Good luck with it hope you find your problem. Jim

10-18-2013, 12:23 PM	#1
gimpie01 Registered User Join Date: Jul 2012 Location: Ohio Posts: 47	72 c10 steering gear box Help' I replaced the input shaft seals(leaking) and now the steering is extermely difficult to turn. It seems as though the rag joint is rubbing against the adjuster with the set bolt, everything appears to be in place.HELP !!!!

10-18-2013, 09:57 PM	#2
hugger6933 Registered User Join Date: Oct 2008 Location: Marianna Arkansas Posts: 7,257	Re: 72 c10 steering gear box Have you tried to take the shaft loose [ from the steering side] to try to turn the box again? How far into the box did you go? Do you think any of the balls in the worm could have gotten out of place? That would leave you with a hard to turn box if you could turn it. Good luck with it hope you find your problem. Jim



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.