MI K1416 Suburban part-out- Rolling Chassis

[1960chevypanel]

Got the mounts, thanks. Do you have this brace?

[VictoriaHardware]

Originally Posted by 1960chevypanel

Do you have this brace?

I assume you're talking about the crossmember. It's heavily rust pitted and has part of a trailer hitch welded to it. It also got chunks cut off when the rest was cut with a torch. So it's not better than what you have now.

[VictoriaHardware]

Parts remaining- prices plus shipping & PP fees

Axle, front $200
'65 Dana 44 Closed Knuckle, 3.73, open carrier, 6 lug, excellent condition, no shipping

Axle, rear $50 SOLD
'65 3.73, open carrier, 6 lug, fair condition, no shipping

Transmission $200 SOLD
'69 SM465 4 spd, no shipping

Cylinder Heads, 3932441 $100 SOLD
Both dated A-9-9. bare castings

Steering Gear w/ pitman arm $125
Integral box, '69 (?)

[VictoriaHardware]

Crossmember $75
K10 manual transmission, with spring mounts and hardware

Lift blocks $50 SOLD
cast iron, rear axle, with clamps

Jounce Bumper Blocks $25
cast iron, front axle

Spring Mounts $25 ea SOLD
Front - forward LH, forward RH
Rear - forward LH, forward RH, rearward RH

[VictoriaHardware]

Brass Fittings- $25 SOLD
brake plumbing, 4 pcs

Clutch Linkage $25
Frame bracket, cross shaft, Rod, Lever w/ Hardware

[1960chevypanel]

Originally Posted by VictoriaHardware

I assume you're talking about the crossmember. It's heavily rust pitted and has part of a trailer hitch welded to it. It also got chunks cut off when the rest was cut with a torch. So it's not better than what you have now.

Ok thanks for checking on it