The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > Info Center > FAQ Truck Tech > Suspension, Steering and Brakes

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Old 08-06-2002, 12:29 PM   #1
ebfabman
Registered User
 
Join Date: Nov 2001
Location: Concord, NC
Posts: 2,489
Replacing upper "A" arm bushings and balljiont

replacing ''A" arm bushings
remove A arm and remove balljoint remove old bushings & shaft
disassembled
screw in one bushing
screw shaft into bushing screw in 2nd bushing
next the balljoint
use the grade 8 bolts
install back on truck
tighten everything up & grease
Some tips. Screw in the first bushing all the way into the A arm. then after greasing the shaft, screw it all the way into the bushing, then unscrew it out one turn. Then screw the other bushing into the A arm. Snug them down good. I have seen the bushings tack welded to the A arm, just be sure to tack them so they can be removed later.
Final tightening/torque should be done when the suspension is aligned.
There may be other ways to do this, but this is how I've done it over the years. If anyone has anything to add please feel free.....eb
Attached Images
 

Last edited by ebfabman; 08-06-2002 at 01:48 PM.
ebfabman is offline  
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 05:52 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com