|
How do I replace the windshield roof bow?
68 Panel truck windshield frame. What is the best way to do this? Do I drill out the spot welds on the old bow from the top roof drip rail, spot weld, prime and seam seal it when done? Or, do I drill out the spot welds from below in the windshield channel, spot weld and prime? I do have the inside header piece cut out and it's going to be replaced too so I can access it from either side. BTW this is the worst part of the drip rail and it looks worse in the pics. it's actually pretty solid.
__________________
It's not rust, it's called patina
Trying to bring a 68 Panel Truck back from the dead. 396 Big Block, 4 on the floor, and a whole lot of rust.
|
09-13-2020, 01:53 AM
Linear Mode
