|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
10-16-2018, 06:51 PM
|
#1 |
|
Registered User
 Join Date: Feb 2018
Location: Red Hook NY
Posts: 130
|
68 nose on a 69 cab mount questions
Hi, I'm building a truck and want to use the 68 nose on my 69 cab. I'm putting this on a No Limit chassis but am having a problem lining up the front fenders to rad support. I'm using a 68 rad support bit it seems too high or maybe the mounts for the rad support are too high. I can get the fender to door alignment ok but would have to push the fenders down about an inch to fit into the rad support and then that throws the door to fender alignment off. Any suggestions? Btw using all original fenders and doors. Thx
Last edited by Sharptrans; 10-16-2018 at 07:23 PM. |
|
|
|
10-16-2018, 07:42 PM
|
#2 |
|
Moderator
 
Join Date: Jun 2017
Location: Cherryville, NC
Posts: 2,155
|
Re: 68 nose on a 69 cab mount questions
67-68 radiator support bushes are different to 68-69....
67-68 and shorter... see http://www.lmctruck.com/icatalog/cb/full.aspx?Page=17 and look at the illustrations... easy fix... 
__________________
Family and country before all others... 2006 Chevy Silverado (Daily Driver) 2012 Chevy Equinox 
|
|
|
|
|
10-17-2018, 11:52 AM
|
#3 |
|
Senior Member
 
Join Date: Sep 2007
Location: Albuquerque NM
Posts: 7,814
|
Re: 68 nose on a 69 cab mount questions
ys, youll have to use the 67-68 rad mounts. I might hav an extra used good set if youre interested
__________________
1967custom |
|
|
|
|
10-17-2018, 08:10 PM
|
#4 |
|
Moderator
Join Date: Jun 2017
Location: Cherryville, NC
Posts: 2,155
|
Re: 68 nose on a 69 cab mount questions
Reach out to No Limits and ask them what supports they recommend....
I suspect they have special brackets in their parts listings....
__________________
Family and country before all others... 2006 Chevy Silverado (Daily Driver) 2012 Chevy Equinox
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
