I hate Windows 88 S10 Blazer - The 1947 - Present Chevrolet & GMC Truck Message Board Network

roae22 · 06-06-2011, 05:34 PM

Ok so i have been messing with my passenger window for quite some time now.. Went and got a new regulator and new motor+ new switch... got everything installed, it works however it will only go down.. and only from the passenger switch on the drivers side control. So thinking it might be the wiring, pull the little plastic clip apart that the switch plus into (on the passenger side) but i was stupid and did not look at the wires before i did this.. Anyone have a clue at which order the wires go back into the clip or any other suggestions on getting the window to work? the wire colors are: blue, blu/white, red, tan, grey. Any help would be awesome. Oh yes and i discovered the regulator acts like a bear trap when removing the motor without disengaging the spring first :p glad to still have my fingers.

ChevLoRay · 06-06-2011, 07:29 PM

Can't answer your question, but I can say

to the board from the Heart of Arkansas.

Hopefully, someone will know the answer.

roae22 · 06-06-2011, 07:37 PM

haha thanks

89chevsj · 06-07-2011, 09:33 PM

try posting in the s10 forums

Tink · 06-08-2011, 08:41 AM

When I get home, I can look in my manuals to see if the window motor wiring is in there - should be.

Otherwise, feel free to come on over to www.s10planet.com - someone there might be able to answer before I can.

cblum · 06-09-2011, 05:30 PM

You have a bad door switch. Not sure which switch because the wiring feeds through both switches. I've had a couple of s10s in my time.

Tink · 06-09-2011, 06:00 PM

I just realized that the wiring in the manual probably isn't going to help - you need pin-out of the wiring going into that connector. So you pulled apart the wiring at the driver's side master switch? I may be able to pull my truck down enough to get to that...

roae22 · 06-16-2011, 03:23 PM

So i went to the dealership got the wiring diagram.. Have it all wired up.. New motor only goes down not up. tried switching wires nothing. Got a new master switch and passenger switch.. Still only goes down not up. I have signal in both wires to the motor however switching them did nothing it wont go up or down. Tried another new motor same issue.... Any ideas or anyone know which vehicle to pull a manual regulator w/ hand crank that will fit?

Thanks for the help BTW

roae22 · 06-16-2011, 03:25 PM

@ Tink, no it was the passenger side but i got the wiring issue resolved... However there is no signal from the master switch for up or down to the passenger window.. checked for broken wires, pulled the dash apart everything seems good... Its very very frustrating

06-06-2011, 05:34 PM	#1
roae22 Registered User Join Date: Jun 2011 Location: Preston, WA Posts: 4	I hate Windows 88 S10 Blazer Ok so i have been messing with my passenger window for quite some time now.. Went and got a new regulator and new motor+ new switch... got everything installed, it works however it will only go down.. and only from the passenger switch on the drivers side control. So thinking it might be the wiring, pull the little plastic clip apart that the switch plus into (on the passenger side) but i was stupid and did not look at the wires before i did this.. Anyone have a clue at which order the wires go back into the clip or any other suggestions on getting the window to work? the wire colors are: blue, blu/white, red, tan, grey. Any help would be awesome. Oh yes and i discovered the regulator acts like a bear trap when removing the motor without disengaging the spring first :p glad to still have my fingers.

06-06-2011, 07:29 PM	#2
ChevLoRay Old Skool Club Join Date: Jun 2001 Location: Benton, AR "The Heart of Arkansas" Posts: 10,880	Re: I hate Windows 88 S10 Blazer Can't answer your question, but I can say to the board from the Heart of Arkansas. Hopefully, someone will know the answer. __________________ Member Nr. 2770 '96 GMC Sportside; 4.3/SLT - Daily driven....constantly needs washed. '69 C-10 SWB; 350/TH400 - in limbo The older I get, the better I was.

06-06-2011, 07:37 PM	#3
roae22 Registered User Join Date: Jun 2011 Location: Preston, WA Posts: 4	Re: I hate Windows 88 S10 Blazer haha thanks

06-07-2011, 09:33 PM	#4
89chevsj error 404 Join Date: Oct 2010 Location: soldotna alaska Posts: 1,252	Re: I hate Windows 88 S10 Blazer try posting in the s10 forums __________________ 89 Chevy swb 350 "SJ" DD turned parts truck. SOLD 90 Chevy ext cab loooongbed. "storm trooper" Rust In Peace. 06 Kia sorento wife's car 06 charger srt8 "lucifer" my toy '12 Kia optima

06-08-2011, 08:41 AM	#5
Tink Registered User Join Date: May 2002 Location: VA Posts: 1,337	Re: I hate Windows 88 S10 Blazer When I get home, I can look in my manuals to see if the window motor wiring is in there - should be. Otherwise, feel free to come on over to www.s10planet.com - someone there might be able to answer before I can. __________________ 69 Chevy C10 88 Sierra 02 2500 Suburban And too many S10s to list!

06-09-2011, 05:30 PM	#6
cblum Registered User Join Date: May 2011 Location: stockholm, nj Posts: 26	Re: I hate Windows 88 S10 Blazer You have a bad door switch. Not sure which switch because the wiring feeds through both switches. I've had a couple of s10s in my time. __________________ 1992 swb pickup, 1998 2500 pickup Last edited by cblum; 06-09-2011 at 05:30 PM.

06-09-2011, 06:00 PM	#7
Tink Registered User Join Date: May 2002 Location: VA Posts: 1,337	Re: I hate Windows 88 S10 Blazer I just realized that the wiring in the manual probably isn't going to help - you need pin-out of the wiring going into that connector. So you pulled apart the wiring at the driver's side master switch? I may be able to pull my truck down enough to get to that... __________________ 69 Chevy C10 88 Sierra 02 2500 Suburban And too many S10s to list!

06-16-2011, 03:23 PM	#8
roae22 Registered User Join Date: Jun 2011 Location: Preston, WA Posts: 4	Re: I hate Windows 88 S10 Blazer So i went to the dealership got the wiring diagram.. Have it all wired up.. New motor only goes down not up. tried switching wires nothing. Got a new master switch and passenger switch.. Still only goes down not up. I have signal in both wires to the motor however switching them did nothing it wont go up or down. Tried another new motor same issue.... Any ideas or anyone know which vehicle to pull a manual regulator w/ hand crank that will fit? Thanks for the help BTW

06-16-2011, 03:25 PM	#9
roae22 Registered User Join Date: Jun 2011 Location: Preston, WA Posts: 4	Re: I hate Windows 88 S10 Blazer @ Tink, no it was the passenger side but i got the wiring issue resolved... However there is no signal from the master switch for up or down to the passenger window.. checked for broken wires, pulled the dash apart everything seems good... Its very very frustrating



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.