What did you do to your truck today? Chapter II

[magwakeenercew2jh]

Originally Posted by 9teen69

Pulled the driveshafts to replace u-joints and carrier bearing...pretty rough. Haven't found a carrier bearing local, guess I'll order that.

Checked the oil and drove mine for the first time in two weeks today. Went to the machinist's to show him the truck...He was closed. Good for him.
So, I settled for taking RAT to the barber that's been asking me for five years if I really had a truck.

for me to finally stop by. He liked RAT.

Hey! On another subject. And, although mine's already done and spinning nicely (for $165), I have a question about carrier bearings and driveshafts.
With the fail rate that I read about in these carrier bearings, how come everyone doesn't just junk the bearing and have a one-piece driveshaft made up?

Why did The General do it with a two-piece?

I'm six inches lower in the back...So, when I had mine done, I measured with that consideration, if that's an issue.