|
02-06-2020, 12:58 PM
|
#1 |
|
Registered User
Join Date: Aug 2014
Location: Stone Mills, ON
Posts: 48
|
1970 C10 BBC Install
For my 396 BBC Install into a 1970 C10, what side should my alternator be installed? The truck has factory air that I intend to resurrect at some point.
|
|
|
|
02-06-2020, 03:42 PM
|
#2 |
|
Almost Satisfied
 
Join Date: Mar 2002
Location: Springfield, MO
Posts: 2,928
|
Re: 1970 C10 BBC Install
drivers side
__________________
1971 C10 Stepside. LSx 6.0 with BTR Stage IV, Speed Engineering Headers, 4L80e transmission w/3200 Circle-D Stall. 3.73. Posi. Purchased this truck when I was 17. I started the rebuild (or take apart) in 1993. I have drug it around all over the country in pieces. Finally back on the road in 2021. "I can't complain, but sometimes I still do. Life's been good to me so far." |
|
|
|
|
02-06-2020, 06:04 PM
|
#3 |
|
Registered User
Join Date: Aug 2014
Location: Stone Mills, ON
Posts: 48
|
Re: 1970 C10 BBC Install
Any suggestions on pulley sets - the ones that I inherited don't seem to line up. Who would be a good source?
|
|
|
|
|
03-23-2020, 06:02 PM
|
#4 |
|
Registered User
Join Date: Aug 2014
Location: Stone Mills, ON
Posts: 48
|
Re: 1970 C10 BBC Install
Anyone? Still struggling with this. I have a long water pump and the 3 belt crank pulley I have is touching my cross member. I tried a 2 belt crank pulley from an SBC and although it clears my cross member it does not line up with my long water pump / pulley. I really don't want to switch water pumps.
Does anyone have a info or a source for a 2 belt crank pulley that lines up with a long water pump? |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
