Restoring Rusty - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**Gregski** · 03-29-2019, 12:44 AM

I recommend you set aside 60 hours for this project... 59.5 to get the stupid lock mechanism out, and 1/2 hour for everything else, ha ha

Top Tip - don't go pockin' anything like a paper clip into that hole in the twisty knob thingie, it's there just to show you that GM engineers have a sense of humor

Top Tip 2 - use a super skinny flat screw driver to push in that little pin thingie in the hole in the picture, that will allow the lock to slide out about 1/4 inch, then do it again to the second pin in the same hole and then it will come all the way out

Fun Level = 2

03-29-2019, 12:44 AM	#11
Gregski Post Whore Join Date: Aug 2014 Location: Sacramento, CA Posts: 10,803	Re: Restoring Rusty I recommend you set aside 60 hours for this project... 59.5 to get the stupid lock mechanism out, and 1/2 hour for everything else, ha ha Top Tip - don't go pockin' anything like a paper clip into that hole in the twisty knob thingie, it's there just to show you that GM engineers have a sense of humor Top Tip 2 - use a super skinny flat screw driver to push in that little pin thingie in the hole in the picture, that will allow the lock to slide out about 1/4 inch, then do it again to the second pin in the same hole and then it will come all the way out Fun Level = 2 Attached Images Last edited by Gregski; 03-29-2019 at 12:51 AM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.