10-04-2002, 10:30 PM | #1 |
Registered User
Join Date: Aug 2002
Location: Melville, SK
Posts: 1,145
|
desktop dyno
Hey, could I get somebody to do a desktop dyno on this engine with a few different cams.
The engine: -350(3970010 block) bored 30 over, 2 bolt main - 3973487 heads(74.47 cc, 1.94/1.5 valves) with typical porting -balanced and blueprinted -10:1 flat tops -Edelbrock performer intake -HEI swapped from newer SBC -Q-jet carb from a 1979 350 -Hedman small tube headers ->2" exhaust through glasspacks The two cam I would like to be dynoed are: -comp magnum series 280H (230 degress intake and exhaust, .480 lift intake and exhaust) -crane powermax (228 degrees intake and exhaust, .480 lift intake and exhaust) This desktop dyno sounds like it would be pretty cool to have - I think I will have to put it on my christmas list. |
10-04-2002, 11:22 PM | #2 |
faster, faster, faster
Join Date: Dec 2001
Location: Houston ,Texas ,USA
Posts: 1,354
|
The numbers for the 280H are 326bhp@5000rpm, and 380ft lbs@4000rpm, And I don't have the exact file for the other cam, but what I got from your numbers on it are a little lower than the first one. 329bhp@5000, and 376ft lbs@4000rpm
__________________
I'm going to Law School, wanna debate? It's good practice. |
10-05-2002, 10:51 AM | #3 |
Registered User
Join Date: Aug 2002
Location: Melville, SK
Posts: 1,145
|
Thats right around where I thought it would be.
Thanks! |
Bookmarks |
|
|