|
01-26-2003, 10:12 PM
|
#1 |
|
Registered User
Join Date: Oct 2000
Location: St. Johns, Arizona
Posts: 2,660
|
Turbo 350 question
As some of you know, the th-350 died in my 'burb.
I was talking to a friend of mine that said that the output shaft on the back of the TH-350 could be removed and replaced without disassembling the tranny. How is this done? The reason I ask is: I have a working TH-350 out of a 2 wheel drive, but the 4-wheel drive has a (much) shorter output shaft to go into the transfer case. Anyone know for sure? I thought that the tranny had to be disassembled in order to change the output shafts.
__________________
my 2¢ - t.i.o.l.i. Bowen 1968 K20 fleet 1969 K10 swb fleet 1972 K10 Suburban 1972 C10 lwb step 1992 K1500 'burb 1995 K2500 'burb 1997 C1500 'burb 1999 K1500 2000 K1500 'burb Why do I own so many Suburbans? |
|
|
|
01-26-2003, 10:21 PM
|
#2 |
|
Registered User
Join Date: Oct 2002
Location: Des Moines WA. (Kent, area)
Posts: 668
|
output shaft
You are correct. You do have to tear into the trans but if you be careful its not hard. Just pull it apart keeping most of the assemblies together. Line the assemblies up on a bench the way they came out. Do this for both transmissions (on differnt benches) swap both tail shafts and reassemble.
__________________
70 chev c10 swb fleet 72 grill, sb 400, 2/4 drop. 68 chev c10 swb fleet Early classic 4/6 drop with 4wheel disc brakes 9"rear 67-8 buckets tilt and A/C Classic GM Truck Club of Washington . |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
