|
06-13-2018, 06:24 PM
|
#1 |
|
Senior Member
 
Join Date: Apr 2000
Location: madison indiana
Posts: 3,840
|
prop valve
I got lucky and found a 14 bolt with a rear disc kit already installed,was wondering if i could use the prop valve off a newer disc to disc truck, instead of one from like inline tube?
__________________
jamie72 72 BB cheyenne -- Restoration getting started.. member #807 http://www.myspace.com/whitetailobsession www.antlertalk.com |
|
|
|
06-20-2018, 10:29 PM
|
#2 |
|
Registered User
Join Date: Jan 2017
Location: wheaton IL
Posts: 659
|
Re: prop valve
When I did my swap on my 86 k30 I drove it for a little while without changing anything, the truck did stop but felt like I was pulling a 2000 lb trailer.
I left the factory proportioning valve and changed the master cylinder to one off a 1999 k3500 4x4 with 4wheel disc brakes. Truck stops amazing and will pretty much lock the tires up with a inch of pedal travel. Even the brake lines threaded in with no issue |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
