Does anybody know?

[62ChevyStep]

does anyone know the spacing/location of the mounting holes on a 60-62 Rear Fleet bumper.

And the mounting hole spacing/location on a 63-66 rear fleet bumper

since the 63-66 rear frames are 33 3/4 inches wide and the 60-62 are 41 3/4 inches wide.

one like this:

[slepysal]

I will mesure my 60's when I get home

[62ChevyStep]

thanks Slepysal......62Chevystep

[slepysal]

ok it mesured 13.75 inches from center to center. The blue lines

[62ChevyStep]

Thanks, I have been unable to find an OEM 60-62 fleet bumper like the one in the picture (it is off a 63-66). I know I can purchase an aftermarket one, but they often are not the same structural quality as the OEM ones, so if I cannot find a OEM 60-62 fleet bumper like the one shown, I will take this one weld the holes and redrill for the 60-62 brackets.

I have a perfect OEM front bumper, so will take both and have them show chrome plated when the time comes.

[slepysal]

you know you can allways "shave '" it , weld the original holes, and weld in the new bolts in the rigght location ,leaving a clean shaved bumper. We used to call them CAL Bumpers.

[62ChevyStep]

yeah I didn't think of that, we use to do that on volkswagons in Cali back in the day (70's and 80's) Uh oh starting to age myself.