|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
09-30-2002, 11:13 AM
|
#1 |
|
Almost Satisfied
 
Join Date: Mar 2002
Location: Springfield, MO
Posts: 2,928
|
U-Joint Dissassembly?????
I have a one piece drive shaft in my short bed. Where the yoke comes out of the TH400 there is a u-joint that connects to the drive shaft. My question is I have never seen a u-joint like this one. It does not have clips and I don't have a clue how to take it apart. It appears to have little plastic tips or nipples coming out of each side of the caps, but I don't know if they have to be drilled out or what. I wish I had a picture.
Can anyone help me out with this. It all goes to the powder coater at lunch time.
__________________
1971 C10 Stepside. LSx 6.0 with BTR Stage IV, Speed Engineering Headers, 4L80e transmission w/3200 Circle-D Stall. 3.73. Posi. Purchased this truck when I was 17. I started the rebuild (or take apart) in 1993. I have drug it around all over the country in pieces. Finally back on the road in 2021. "I can't complain, but sometimes I still do. Life's been good to me so far." |
|
|
| Bookmarks |
|
|
Threaded Mode